Dynatech Elevation
QUASAR T25 A3 / QUASAR T25
QUASAR+T25 Q A3 / QUASAR+T25 Q

The QUASAR T25 overspeed governor is a completely innovating design that allows integrating the governor along with the safety gear and its steering mechanism into a single unit.
This concept can easily be installed into any type of frame, either gantry or cantilever, and may be used regardless of the final layout of the guide rails (either toe-in or toe-out).
This is the optimal solution for lifts with a reduced pit, both for its small dimensions and the compactness of the unit.
The required rope must be of 4mm. Please read the instructions for use and maintenance in order to correctly use it.
The integrated safety gear may be any of the models in Dynatech’s ASG safety gear range.
Both the high performance of this small governor and that of ASG safety gears provide the customer with the solution for almost every of his/her needs in a single product; thus saving the additional costs from the combination of different products for different needs.
Since this is a governor incorporating a pulley with a diameter of just 120mm, A3’s response time against the UCM is extraordinarily fast, which results in higher safety within the installation.

QUASAR T25 A3
Electrically-operated anti-creep system:
24, 48 or 190 VDC + Control sensor (Included).
When using the electronic device D-Box along with the Anti-creep System, the COIL MUST BE OF 24 VDC.

QUASAR T25
Electrically-operated remote Tripping System:
24, 48 or 190 VDC (Included).

QUASAR T25 overspeed governor is supplied along with ASG progressive safety gear integrated as a safety unit. The combination of the governor’s high performance and that of the safety gear, results in the following application field of the unit:

TRIPPING
:
BIDIRECTIONAL or UNIDIRECTIONAL

General performance:
- MAXIMUM RATED SPEED: 2 m/s
- MINIMUM RATED SPEED: 0.1 m/s

CLOSE-UP OF TRIPPING SPEEDS:

- BIDIRECTIONAL or UNIDIRECTIONAL:

Minimum: 0.7 m/s
Maximum: 2.33 m/s.

- UNIDIRECTIONAL
(ONLY THE
QUASAR LS+T25 Q MODEL):
Minimum: 0.30 m/s
Maximum: 0.69 m/s

Pulley diameter: 120 mm
Rope diameter: 4 mm
Overspeed contact included
Rope release prevention system included
Rope loosening contacts included
230 VAC - 190 VDC Rectifier (optional)

According to the standards: 
EN 81-20 and EN 81-50.

Operating and maintenance instructions

See video: Examples of use of our products (2D)
Dynatech
Poligono Ind. de Pina de Ebro. Sector C.p-9. 50750 Pina de Ebro. Zaragoza-España(Spain)
© 2005 -2017 Dynatech Legal Aspects